I keep seeing new guys skip the chalk line on long cuts and it drives me nuts

Back when I started, my boss in Tacoma would hand me the chalk box before I even touched the saw. Now I watch people try to cut a 16-foot sheet of plywood freehand with a circular saw, just following a pencil mark they can't even see halfway down. The line goes wavy, the cut is off by an eighth of an inch, and then the whole piece is junk. That chalk snap is a clear guide you can follow with your shoe, not just your eyes. I've seen more material wasted in the last two years from this one lazy step than I care to count. It takes ten seconds and saves a sixty-dollar sheet. Has anyone else had to reteach this basic step lately, or is it just me?

Tbh, I just wasted $75 on a 'professional' bread lame that's basically a toothpick on a stick

Figured out how to make LinkedIn work for Edmonton networking

Kept getting overwhelmed by too many irrelevant profiles. Set up a saved search with Edmonton as the location and my industry. It cuts out the noise and focuses on local leads.

Shoutout to the crews still doing full site prep before laying anything

Lately, a lot of new guys in my town skip checking subfloors and just slap down planks. I think this leads to bumps and gaps later, but everyone acts like it's fine to save time. Do you really think cutting prep is okay, or are we setting ourselves up for fails?

Wind made me rethink my whole astro setup

I always thought my flimsy tripod was fine for catching planets from my deck. After a gust shook my scope and ruined a Jupiter shot, I see why a heavy base helps. In my experience, a stable mount can turn a fuzzy blob into a clear photo, but your mileage may vary.