PSA: Stop letting old-timers tell you hand-tight is good enough on tube plugs
A retired hand at the plant in Gary told me he never used a torque wrench on plugs in 30 years, and I almost listened until I watched a hydro test spray a joint at 400 psi. You torque to spec or you own that failure, so what's your go-to spec sheet when the drawings don't list one?
My torque wrench sat in the truck for two years before I finally used it, so I am not throwing stones here. The Gary story is the whole point though, because "never had a problem" just means the guy got lucky enough times before he retired. Once the drawings are quiet, I go to the plug maker's spec sheet, and if that is missing too, I torque to a standard table and write the number on the pipe with a paint pen.