Everyone here says heat the screws on old Leicas. I tried it on a IIIf last week and it cost me $140
I know the common advice on this forum is to hit stubborn body screws with a soldering iron before you even think about forcing them, and I want to push back. Last Tuesday I was pulling the top plate off a 1954 IIIf that came in from a guy in Cleveland, and I went straight to the iron like everyone says. Two screws came out fine, but on the third one I got the aluminum too hot and the threads pulled clean out of the body casting. That turned a $90 CLA into a $140 job because I had to order a helicoil kit and spend an extra evening tapping it back to size. What worked way better for me was just soaking the whole area in penetrating oil for a full day and then using a proper hollow ground driver with a slow, even twist. The heat advice probably comes from people working on steel bodies, not these soft castings. Has anyone else had heat bite them on the older Barnack bodies, or am I just heavy handed with the iron?