I finally found the bad pin by wiggling the harness instead of re-pinning the whole connector
I was chasing an intermittent autopilot drop on a King Air 200 in Wichita two weeks ago, and I'd already pulled and re-pinned the same connector twice with no luck. The plane would fly fine on the ground, then the customer would come back saying it dropped out in climb. I was standing on a ladder with the panel opened up, and out of frustration I just grabbed the harness bundle and gave it a light tug while watching the meter. The reading jumped around right at pin 14, and when I looked close the wire was barely hanging on inside the crimp. What got me is that the pin looked fine from the outside, and a visual check would never have caught it. I replaced that one pin and we did a full flight test with no dropouts. Now I want to know, is there a better way to find these hidden crimp failures than just wiggling wires and hoping the meter twitches? I feel like I got lucky more than I got smart.