I stopped swapping whole control boards and started checking the ribbon cable first
Had a dryer last Tuesday that wouldn't start, and my gut said control board right away. Before I ordered a $140 replacement, I pulled the ribbon connector and saw two pins bent flat. I straightened them with a tiny flathead and a pair of tweezers, plugged it back in, and it fired up on the first try. Took me about 15 minutes instead of a week waiting on a part. I have been doing this 9 years and I still catch myself jumping to the expensive part first. Now I keep a cheap magnifier light on the truck and look at every connector before I touch a board. How many of you keep a known-good control board around just to rule it out before you order a new one?