Rant: the 2 cent safety wire trick that ended my connector pin nightmare
I spent 4 months fighting the same stupid problem on the avionics rack of a King Air out of a shop in Bakersfield: pins backing out of a cannon plug after a few flight cycles, no matter how careful I was with the crimper. I tried the fancy ratcheting tool, I tried a different pin kit, I even got the guy who's been doing this 25 years to watch me and tell me what I was doing wrong. Then I figured out the issue was never the crimp, it was that I was holding the wire bundle dead still while pushing the pin in, so the whole connector was flexing just enough to seat it shallow. What actually worked was tying off the bundle with a scrap piece of .032 safety wire looped around a nearby standoff, just enough tension to hold it steady, then pushing the pin straight in with one clean motion. Did all six connectors that way and never had a pin back out again on that plane. Now I keep a 3 foot coil of safety wire in my box just for this. Any of you running into shell flex on these old plugs, or is it just the way I was working?