Loading…
6
Took me 2 hours to figure out why my load chart kept saying one thing and the buzzer said another
Last week I was setting a 4,000 lb HVAC unit on a roof in Garland and my LMI kept beeping even though the chart said I was fine. Turned out my boom angle sensor was reading 2 degrees off after a tech swapped the cable and mounted it a hair crooked, which ate up my whole morning. Anyone else had a sensor drift on them like that, or do you just swap the part and move on?
1 comments
Log in to join the discussion
Log In1 Comment
scott.miles1mo ago
Garland heat alone can throw those sensors off by a degree or two before you even touch the mount.
7