My 18 inch brush head popped off 20 feet up and landed in a customer's crockpot
So last Tuesday I'm up on the roof of this old Victorian over on Ash Street doing a routine sweep, nothing fancy, and I'm feeling pretty good about myself because I'd already knocked out two jobs that morning. I feed the rods down and right around the 20 foot mark I hear this little pop, and before I can even react the brush head just drops clean off the rods and disappears down the flue. I stand there for a second, dumbfounded, and then I hear it, this hollow ceramic clang from inside the house. I climb down and knock on the door, and the homeowner (sweet old lady, been in that house since 1974) walks me back to the kitchen, and there's my brush head sitting dead center in her crockpot of chili that had been simmering since 7am. I pulled it out with tongs, apologized about six times, and she just laughs and says her husband never liked the chili anyway. The threaded connection on my rod had worn down to basically nothing and I never checked it, which is on me. I ordered a new set that night, but now I'm paranoid and checking threads before every job. Any of you had a fitting fail like that mid-sweep, and how often are you swapping out rods?