PSA: the torque wrench class at the Albany hangar changed how I sign off on engine work
Sat through a free torque class at the county hangar in Albany about 6 weeks ago, mostly because the coffee was free and I had nothing better going on. The instructor made us torque the same bolt 5 times with a beam wrench and a clicker side by side, and the clicker was off by close to 8 percent on the third pull. Now I check calibration tags before I touch anything on a engine mount and write the tool number in the log. Anyone else get burned by a wrench that was quietly out of spec, or am I just late to this?
Funny timing on this. Back when I was doing bike work at a shop, we had one torque wrench that everyone fought over because it "felt right." Turns out it had been dropped off a bench a year before and nobody sent it out, so it was reading way low the whole time. We only found out when a buddy borrowed it for a motorcycle head and snapped a stud. After that the owner hung a cheap fish scale off the handle once a month to sanity check it, which is about as low tech as it gets. Anyway, good on you for writing the tool number down, that paper trail matters way more than people admit.